Hi Giovanni,
thank you very much. In my sdStart, I configured now some bits found in the STM32F4-Manual for CR1, CR2 and CR2. This did the trick! Wohoo!
After a closer look, I saw that these were exactly the same bits like defaulted in usart_init(). The exact trick was to zero out the CR3 in ...
Search found 2 matches
- Thu Mar 05, 2015 9:12 pm
- Forum: STM32 Support
- Topic: Understanding the Serial driver
- Replies: 3
- Views: 2997
- Thu Mar 05, 2015 3:16 pm
- Forum: STM32 Support
- Topic: Understanding the Serial driver
- Replies: 3
- Views: 2997
Understanding the Serial driver
Hi there on the other end of the internet,
I want to receive some data via the serial driver and ChibiOS 2.6.6 using an Olimex STM32E407 development board. The sender of the serial data is EnOcean Pi, which is connected to 3,3V, GND, RX and TX. TX of Sender is connected to PD6 (USART2 RX) and RX of ...
I want to receive some data via the serial driver and ChibiOS 2.6.6 using an Olimex STM32E407 development board. The sender of the serial data is EnOcean Pi, which is connected to 3,3V, GND, RX and TX. TX of Sender is connected to PD6 (USART2 RX) and RX of ...