Hi folks,
I wonder why SPI is always disabled after the transfer is finished.
Is there any reason?
How can I avoid this behaviour?
Thanks and best regards.
edit:
we have 16 bit, cpol=1, cpha=1, master, pullup-resistors enabled (tried various settings)
SPI STM32F405 Topic is solved
Moderators: RoccoMarco, barthess
-
Giovanni
- Site Admin
- Posts: 14455
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1076 times
- Been thanked: 922 times
- Contact:
Re: SPI STM32F405 Topic is solved
Hi,
Which version are you using, in latest one SPE is not disabled after each transfer.
Giovanni
Which version are you using, in latest one SPE is not disabled after each transfer.
Giovanni
Re: SPI STM32F405
Thanks, Giovanni, I see,
maybe I should upgrade to the latest version which I didn't notice beeing available.
btw. can I subscribe somewhere in order to receive announcements on new versions?
maybe I should upgrade to the latest version which I didn't notice beeing available.
btw. can I subscribe somewhere in order to receive announcements on new versions?
-
Giovanni
- Site Admin
- Posts: 14455
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1076 times
- Been thanked: 922 times
- Contact:
Re: SPI STM32F405
Hi,
New versions are announced in the "Releases" forum, you may subscribe on that specific one.
Giovanni
New versions are announced in the "Releases" forum, you may subscribe on that specific one.
Giovanni
Who is online
Users browsing this forum: No registered users and 8 guests