Hello to all of you, I'm going to program a board of STMicroelectronics SPC56M with spc5studio, but use ubuntu. I tried some plugin for eclipse, since spc5studio is based on it, but found nothing. I was advised to ask you, does anyone know how I could do? Maybe if I can use an IDE other than STStudio ??
Thanks for your attention!!
How can I program a SPC56M from Ubuntu?
-
- Posts: 1
- Joined: Tue Dec 20, 2016 3:00 pm
- Giovanni
- Site Admin
- Posts: 14563
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1111 times
- Been thanked: 937 times
- Contact:
Re: How can I program a SPC56M from Ubuntu?
Hi,
I don't think there is much Linux support for SPC5, you should see if HighTec and Lauterbach have Linux-based solutions.
Giovanni
I don't think there is much Linux support for SPC5, you should see if HighTec and Lauterbach have Linux-based solutions.
Giovanni
Who is online
Users browsing this forum: No registered users and 1 guest