I try use new Chibios 3.0, but when I try run some peripheral, then I stuck in:
Code: Select all
DMAv1/stm32_dma.c:69:40: error: 'STM32_DMA1_STREAM1_EVENT_NUMBER' undeclared here (not in a function)It's look that:
Code: Select all
/*===========================================================================*/
/* Driver exported variables. */
/*===========================================================================*/
/**
* @brief DMA streams descriptors.
* @details This table keeps the association between an unique stream
* identifier and the involved physical registers.
* @note Don't use this array directly, use the appropriate wrapper macros
* instead: @p STM32_DMA1_STREAM1, @p STM32_DMA1_STREAM2 etc.
*/
const stm32_dma_stream_t __stm32_dma_streams[STM32_DMA_STREAMS] = {
{DMA1_Channel1, &DMA1->IFCR, 0, 0, STM32_DMA1_STREAM1_EVENT_NUMBER},
{DMA1_Channel2, &DMA1->IFCR, 4, 1, STM32_DMA1_STREAM2_EVENT_NUMBER},
{DMA1_Channel3, &DMA1->IFCR, 8, 2, STM32_DMA1_STREAM3_EVENT_NUMBER},
{DMA1_Channel4, &DMA1->IFCR, 12, 3, STM32_DMA1_STREAM4_EVENT_NUMBER},
{DMA1_Channel5, &DMA1->IFCR, 16, 4, STM32_DMA1_STREAM5_EVENT_NUMBER},
#if STM32_DMA_STREAMS > 5
{DMA1_Channel6, &DMA1->IFCR, 20, 5, STM32_DMA1_STREAM6_EVENT_NUMBER},
{DMA1_Channel7, &DMA1->IFCR, 24, 6, STM32_DMA1_STREAM7_EVENT_NUMBER},
#endif
#if STM32_DMA_STREAMS > 7
{DMA2_Channel1, &DMA2->IFCR, 0, 7, STM32_DMA2_STREAM1_EVENT_NUMBER},
{DMA2_Channel2, &DMA2->IFCR, 4, 8, STM32_DMA2_STREAM2_EVENT_NUMBER},
{DMA2_Channel3, &DMA2->IFCR, 8, 9, STM32_DMA2_STREAM3_EVENT_NUMBER},
{DMA2_Channel4, &DMA2->IFCR, 12, 10, STM32_DMA2_STREAM4_EVENT_NUMBER},
{DMA2_Channel5, &DMA2->IFCR, 16, 11, STM32_DMA2_STREAM5_EVENT_NUMBER},
#endif
};I try found that, but its nowhere, probobly it's shut be STM32_DMA1_STREAM1 not STM32_DMA1_STREAM1_EVENT_NUMBER?
