Nucleo-32 boards

[Tabulous]

Hi Giovanni,
have you got the Nucleo32 boards running in Chibistudio and OpenOCD ?

if so what OpenOCD files did you use ? The ST-Link looks like it has two interfaces and thus will need to tell OCD which one to use

I have two F031K6 and F042K6 boards that im trying to get running.

[Giovanni]

Hi,

The OpenOCD contained in the current ChibiStudio is unable to use those devices (same problem here). I will include a patched one in the next release, I am able to build it myself now.

As soon it is done I will post it here first.

Giovanni

[Tabulous]

can you share the OCD files ?

[Giovanni]

Rocco Marco just sent this to me, I will not be able to test it until weekend.

openocd.7z

(1020.26 KiB) Downloaded 252 times

Giovanni

[Giovanni]

Tested, it works.

Giovanni

[Tabulous]

Tested, it works.

Giovanni

what target files did you select ?

[Giovanni]

stm32f0_stlink for both, under targets.

Giovanni

[Tabulous]

stm32f0_stlink for both, under targets.

Giovanni

so no interface script ? i.e normally the it is setup like this

-c "telnet_port 4444" -f "interface/stlink-v2-1.cfg" -f "${file_prompt}"

[Giovanni]

It would just give a warning but work anyway.

Giovanni

[Tabulous]

It would just give a warning but work anyway.

Giovanni

stm32f0_stlink is depredicated and says should not be used ???

can you copy and past your Arguments from the tool launch