Hi Giovanni,
I'm working with ChibiOS 2.6.7 on STM32F103RCT6, can i use CAN and USB in one project(not at the same time)?
when i do this , i find these errors:
2.6.7/hal/platforms/STM32/USBv1/usb_lld.c:280: multiple definition of `Vector8C'
2.6.7/hal/platforms/STM32/USBv1/usb_lld.c:291: multiple definition of `Vector90'
what can i do next?
Thanks!
Can use a usb and CAN not at the same time on STM32F103RCT6
Moderator: RoccoMarco
-
Giovanni
- Site Admin
- Posts: 14893
- Joined: Wed May 27, 2009 8:48 am
- Has thanked: 1202 times
- Been thanked: 997 times
Re: Can use a usb and CAN not at the same time on STM32F103R
Hi,
On the F1 USB and CAN share memory and IRQ, I am not sure if it is possible to do something to do about that. You may try to edit drivers and write a shared ISR in your code but there could be other problems.
Giovanni
On the F1 USB and CAN share memory and IRQ, I am not sure if it is possible to do something to do about that. You may try to edit drivers and write a shared ISR in your code but there could be other problems.
Giovanni