Hi All,
Is there any way to store short data to flash from my code? For example I need to measure 8 channel temperatures with pt100. It would be very cool, if I can store normalization parameters to flash.
thx
Zamek.
Storing parameters to nonvolatile memory
Moderator: RoccoMarco
Storing parameters to nonvolatile memory
Last edited by zamek on Sat Mar 23, 2013 7:57 pm, edited 1 time in total.
Re: Storing parameters to nonvolatile memory
By "normalized parameters", you mean some values you need for calculation? Why not using const then?
Otherwise, this might be of your interests.
~ Tectu
Otherwise, this might be of your interests.
~ Tectu
Re: Storing parameters to nonvolatile memory
Hi,
Yes, I have to calculating the correct value based on the linear equation. I need to store 4 parameters to each channel.
If I should store it in const, I need to recompile the sw, if somebody changes a sensor.
If I should store it to flash, I can make an auto standardization.
thx,
Zamek
Yes, I have to calculating the correct value based on the linear equation. I need to store 4 parameters to each channel.
If I should store it in const, I need to recompile the sw, if somebody changes a sensor.
If I should store it to flash, I can make an auto standardization.
thx,
Zamek