Page 2 of 2
Re: Serial comm over UART2, where did I go wrong?
Posted: Tue Jan 29, 2013 10:14 am
by Giovanni
It is a good idea designing the board thinking to your board.h at the same time and test often on some dev board like the Discovery. This can save redesigns and money.
Giovanni
Re: Serial comm over UART2, where did I go wrong?
Posted: Wed Jan 30, 2013 9:07 pm
by alex31
i follow this workflow, with some success :
° make the function/pin assignation with stmico tool microxplorer
(
http://www.st.com/internet/com/SOFTWARE ... _setup.zip)
° write the board.h according to the config made with microxplorer for anything static
° use dynamic configuration only when static conf with board.h is not an option.
Alexandre