ChibiOS Free Embedded RTOS

Hi,

I have started a port for netduino2 which I have, I did not figure out how you were building the port pins board.h files, I build them from a csv file and awk, which was a bit crude, but works.

I managed to get this woking on the netduino2, blinking the LED and a serial port on UART2 PA2 and PA3

http://netduino.com/netduino2/netduino2 link.

I have some more work to do, will post some more if anyone is interested.

Regards,

Pete

Thank you very much for sharing your work. We've sent out a tweet - Probably someone will get interested and can help you.

pete_jan wrote:I did not figure out how you were building the port pins board.h files, I build them from a csv file and awk, which was a bit crude, but works.

The board files are generated from an eclipse plugin inside the ChibiStudio IDE.


~ Tectu

Attached patch against branches/stable_2.6.x for netduino2 board, and demo project, using board generator fmpp

Hi,

The board files contain a link not C code, you should also include the .chcfg file too.

Giovanni

Hi,

Sorry about that, I though svn added them as files not links.

try attached patch.

I could not figure how you had included the cfg file, as I had them in gencfg to build them, but found an example, does that work?

Peter