SDADC3 faults on STM32F373 @ 3.0-git
Posted: Sat Oct 18, 2014 5:43 pm
I turn back to the processing of ADC and came across a problem: after starting the firmware SDADCD3 falls (even without a halt).
With that SDARC1 works without problems.
Configuration: https://github.com/vooon/miniecu/blob/m ... adc.c#L198
It fails if i uncomment adcSTM32Calibrate(&SDADCD3); or adcStartConversion(&SDADCD3, &sdadc3group, p_flow_samples, 1);.
--- While i write i found bug ---
STM32F37x/adc_lld.c 447
RCC enable should be for SDADC3.
And change it fixes my problem.
With that SDARC1 works without problems.
Configuration: https://github.com/vooon/miniecu/blob/m ... adc.c#L198
It fails if i uncomment adcSTM32Calibrate(&SDADCD3); or adcStartConversion(&SDADCD3, &sdadc3group, p_flow_samples, 1);.
--- While i write i found bug ---
STM32F37x/adc_lld.c 447
Code: Select all
#if STM32_ADC_USE_SDADC3
if (&SDADCD3 == adcp) {
bool b = dmaStreamAllocate(adcp->dmastp,
STM32_ADC_SDADC3_DMA_IRQ_PRIORITY,
(stm32_dmaisr_t)adc_lld_serve_dma_interrupt,
(void *)adcp);
osalDbgAssert(!b, "stream already allocated");
dmaStreamSetPeripheral(adcp->dmastp, &SDADC3->JDATAR);
rccEnableSDADC2(FALSE);
PWR->CR |= PWR_CR_SDADC3EN;
adcp->sdadc->CR2 = 0;
adcp->sdadc->CR1 = (adcp->config->cr1 | SDADC_ENFORCED_CR1_FLAGS) &
~SDADC_FORBIDDEN_CR1_FLAGS;
adcp->sdadc->CR2 = SDADC_CR2_ADON;
}
#endif /* STM32_ADC_USE_SDADC3 */
RCC enable should be for SDADC3.
And change it fixes my problem.
