Hello sam0737 and Giovani ,
I am part of a group of people who are doing a university project in Spain . We are making the acquisition of data for a bike in the MotoStudent program. Let's use an Arduino board and a mobile Android device to store and display the results in real time to the pilot .
After much research and on the basis that we should use an Arduino Due ChibiOs saw and liked as RTOS . Initially we were going to use the option of programming from the Arduino IDE , by a bookcase that locate in rtoslibs . The problem is that this library does not have support for Hal and we can not control all the processes as we should.
After investigating this and we have seen you and we implementation questions have arisen and several problems. We ask both help and clarification to our doubts and ignorance , our interest is further unleash the development , of course .
Current state in which we find :
We downloaded the latest version of ChibiStudio Preview 6.7 . We downloaded the ChibiOs has modified for the Arduino Due sam0737 . ChibiStudio delete the entire folder and copy the ChibiOs of sam0737 . Indicate that you are using Windows 7 32 bits and 64 bits.
We are following the demo of the Arduino Due and as indicated in the readme for this sample, follow the steps.
• The first problem I see is that the version that uses sam0737 ChibiOs is an unstable 2.5.2 while the current is 2.6.x Know if this point may be affecting the outcome of the solution.
• Secondly it has come to our attention that the mcuconf.h file is empty and has no data . We do not know if this is normal or not .
• Third, we find that following the steps of the demo for the Arduino Due ChibiOs following the readme . By using the "cs -make all" to compile have continued to create problems :
http://ferdiado.com/MotoStudent/Fail_cs-make.txtContinue until the end of the compilation without creating any files , of course .
We have associated the Path as you indicate and know they are as system variables .
• However we do use the "make" sets the default ChibiStudio yes we see that it works and we have the mkdir error in bookstores inidcadas above error but then you jump on the Seller pal .
http://ferdiado.com/MotoStudent/Fail_make.txtAs we see gives us just run in association pal_lld.h Ppio failure. We are stuck at this point.
If we remove any other use of this library we compile a bin file, but we have not tried to compile it, we have this outstanding point, but it really is not useful because we can not access the Arduino board as needed.
We have another set of questions but in principle we believe that resolving this point we have solved much of other questions .
Thanks for the reply .
Fernando .
