how to program stm32f4 board in chibistudio

[Pask]

Hi, i use chibistudio to develope stm32f4's code.
I want to load .elf file on the board without start necessarily debugger mode.
unfortunately chibistudio does not offer a run or debug configuration mode to load only .elf file on the board.
How i can do it?
thanks.

[Giovanni]

Once you debugged it, the code has also been flashed. You may create a flash-only script using OpenOCD but I never tried it, see the OpenOCD documentation.

Alternatively you can use an external application, there are several for the STM32, even open source.

Giovanni

[mobyfab]

If you only need to flash the board, the easiest solution is this:

https://github.com/fpoussin/QStlink2/releases
It loads the .bin into the flash.

Otherwise during debugging the flash is programmed as well.