Hi,
I am planning to use nRF51822 with chibios. I want to know about. how to program this controller.
I am planning to buy following module.
https://www.aliexpress.com/item/NRF5182 ... b61df5d9a8
How to program nRF51822
-
ep.hobbyiest
- Posts: 94
- Joined: Sun Jun 26, 2016 5:22 pm
- Has thanked: 4 times
- Been thanked: 1 time
Re: How to program nRF51822
I have similar boards and I one baseboard with pins for programming. As a programmer I use the st-link on a STM32F4-Discovery, but any SWD programmer should do.
Cheers,
Fabio Utzig
Cheers,
Fabio Utzig
-
DeusExMachina
- Posts: 223
- Joined: Tue Apr 03, 2012 5:08 am
- Has thanked: 3 times
- Been thanked: 3 times
Re: How to program nRF51822
Yes, openOCD supports ST-Link2 and it works quite well with nrf51822.
just try something like this with OpenOCD10 in "Debugger" tab
Config options
commands
just try something like this with OpenOCD10 in "Debugger" tab
Config options
Code: Select all
-f interface/stlink-v2.cfg -f target/nrf51.cfg -s c:/ChibiStudio/tools/openocd10/scriptscommands
Code: Select all
set mem inaccessible-by-default off-
ep.hobbyiest
- Posts: 94
- Joined: Sun Jun 26, 2016 5:22 pm
- Has thanked: 4 times
- Been thanked: 1 time
Re: How to program nRF51822
Thanks.
And i got few tutorials as well.
I was looking for for example code for nrf51822 processor. I got one in chibi-contri.
But while compiling i got following error. I think problem with linking.
here is error.
And i got few tutorials as well.
I was looking for for example code for nrf51822 processor. I got one in chibi-contri.
But while compiling i got following error. I think problem with linking.
here is error.
Code: Select all
make -j4 all
make: *** No rule to make target `chcoreasm_v6m.S', needed by `build/obj/chcoreasm_v6m.o'. Stop.
make: *** Waiting for unfinished jobs....
Compiling crt0_v6m.S