Page 1 of 1
Load firmware with st-link Linux
Posted: Thu Mar 29, 2012 4:36 pm
by PavloT
My 2-cents about STM32 under Linux:
Today I notice that
st-link implementation from Texane has flash utility.
Usage is the following (tested on STM32VL-Discovery):
Code: Select all
st-flash write v1 demos/ARMCM3-STM32F100-DISCOVERY/build/ch.bin 0x8000000
Quite useful to use in make files when you don't need a debug session.
Re: Load firmware with st-link Linux
Posted: Thu Mar 29, 2012 5:56 pm
by Giovanni
Thanks for sharing
Giovanni
Re: Load firmware with st-link Linux
Posted: Thu Mar 29, 2012 6:25 pm
by Badger
here's the command for using
dfu-util with the device in boot loader mode and connected via usb:
Code: Select all
dfu-util -a 0 --dfuse-address 0x08000000 -D build/ch.bin
Re: Load firmware with st-link Linux
Posted: Sat Mar 31, 2012 12:46 pm
by mobyfab
Re: Load firmware with st-link Linux
Posted: Mon Apr 02, 2012 9:46 pm
by PavloT
It is really nice tool (at least for my Windows friends who hate CLI), but seems it is not usable for STM32VLDiscovery
Does qstlink2 support Stlink v1?
I saw this message in 49-stlinkv2.rules
Code: Select all
# stm32 discovery boards, with onboard st/linkv2
# ie, STM32L, STM32F4.
# STM32VL has st/linkv1, which is quite different
Re: Load firmware with st-link Linux
Posted: Wed Apr 04, 2012 4:09 pm
by mobyfab
It only supports stlink V2. it does GUI and CLI.